Equipment quick reference

Aesthetic Laser - Quick Reference

For sample pilot use only

Demo note: use this page for sample pilot guidance only.
Status Ready for Demo
Device Type Aesthetic Laser
Reviewed Today
Quick Action

Start here before using the laser.

  1. Confirm treatment area
  2. Put on protective eyewear
  3. Verify device readiness
  4. Select settings
  5. Stop if anything looks off
How to Use Safety Cleaning Help
Device Xerf / Cynosure
Room Laser Room
Use note Keep this page open while reviewing setup, safety, and cleaning guidance.
Embedded Ready Check

Check operator and room readiness.

Use this only after the Quick Action checklist. Ready Check stays embedded here so the page remains an equipment quick reference first.

CLEARED

All required pilot signals are present for this room and device context. Proceed with the demo walkthrough using the guidance below.

User identity Avery Lane · Aesthetic Clinician
Room / device context Laser Room · Xerf / Cynosure · QR confirmed
Avenue verified Training readiness Pilot training evidence is current for the Laser Room workflow.
Upstream valid License-validity Mock upstream license-validity signal is present for demo scope.
Upstream covered Supervising coverage Mock upstream supervising assignment is present and available.
Fail-closed behavior If any required signal becomes unavailable, stop and call the supervisor before continuing.

Avenue verifies identity, room/device context, and training readiness. License-validity and supervising coverage are upstream-attested.

Equipment guidance

Operator quick-reference sections

What this is

Sample quick-reference page for the demo laser.

Use this page as a short operator guide for the Xerf / Cynosure device in the Laser Room during the sample pilot.

Typical Uses

When to land here

  • Room entry confirmation before setting up the laser demo.
  • Operator coaching during pilot onboarding and supervised dry runs.
  • Quick-reference confirmation for the Laser Room device context.
  • Fail-closed review when training or upstream coverage signals are missing.
Before Use

Confirm the room and operator first

  • Scan the Music City Prep room QR and confirm that the page identifies the Laser Room.
  • Confirm the device listed here matches the Xerf / Cynosure console in the room.
  • Run Ready Check and verify the result is appropriate for the demo scope.
  • Make sure protective eyewear and demo consumables are present before powering the device.
How to Use

Equipment-page workflow

  1. Open the room QR and land on this equipment page.
  2. Use the Quick Action card to run Ready Check for the current operator.
  3. Review the setup, safety, and do-not-use sections before enabling the console.
  4. Continue only within demo scope and stop immediately if the readiness state changes.
Safety Checks

Visible before startup

  • Protective eyewear is available for everyone in the room.
  • Room signage is visible and the access door is controlled during operation.
  • Handpiece, console, and cables show no obvious damage before startup.
  • Emergency stop and shutdown procedure are reviewed before activation.
Do Not Use If

Stop conditions

  • Ready Check returns NOT CLEARED.
  • The room QR, device label, and page context do not match.
  • Upstream license-validity or supervising coverage is unavailable for demo scope.
  • The console shows a fault, missing accessory, or any unexpected warning state.
Cleaning / Maintenance

After the walkthrough

  • Power down according to the device workflow before post-demo wipe-down.
  • Clean room-touch surfaces using the approved clinic process for demo turnover.
  • Inspect handpiece and cable routing before storing the setup.
  • Escalate any console damage or repeated warnings through the help path below.
Need Help

Escalate instead of guessing

  • Room support: Ask the supervising lead assigned to the Laser Room.
  • Equipment concern: Hold the console in safe state and contact the demo operator lead.
  • Signal mismatch: Do not proceed until the upstream license-validity and supervising coverage signals are present.